CYCLOPS

 

The CYCLOPS extension has a single pulley for rapid loop ‘n go rigging.  Simply pass the loop of rope through the tack pulley on the sail and hook it over the single pulley on the extension.  A single pull applies full downhaul tension in seconds.

All the ropes and pulleys are kept in perfect alignment to eliminate a lot of the friction and makes up for any loss of leverage from less pulleys.
A built-in handle negates the need for any tool, and stuff into the downhaul pocket on the sail.

Formuline rope is used to further reduce friction and minimize rope wear.

Faster, simpler rigging.

/ SINGLE LOOP-GO PULLEY
/ EFFICIENT PULLEY ALIGNMENT
/ NEW STAINLESS STEEL AUTOMATIC COLLAR
/ STAINLESS STEEL BUTTON AND MECHANISM
/ ZERO CM SETTING
SIZEDIAMETERMATERIALROPEWEIGHT
24cmWAVECARBONFORMULINE0,48
36cmWAVECARBONFORMULINE0,58
24cmWAVEALLOYFORMULINE0,66
36cmWAVEALLOYFORMULINE0,76

FAQ

THE PUSH BUTTON DOES NOT COME BACK TO THE ORIGINAL POSITION - WHAT CAN I DO?

Rinse your extension thoroughly with water and make sure there is no sand and dust inside. Then try to press the button several times to help to get back to the correct position

CAN I USE THE EXTENSION ON THE MAXIMUM SETTING?

Yes

CAN I USE MY EXTENSION ON "0 CM" SETTINGS?

Yes. To use an extension on a “0” setting simply remove the hinged collar

HOW TO SET THE EXTENSION ON A "2 CM" SETTING?

The 2 cm setting is positioned 90° degrees to the rest of settings just above the mast foot.

HOW TO AVOID THE OXIDATION ON MY ALUMINIUM EXTENSIONS?

Always derig your sail and rinse your extension with fresh water after every session. Do not leave your alu extension inside the mast while you do not use the sail.

WHERE CAN I BUY SPARE PARTS?

You can order these parts at your nearest Severne dealer or distributor. Use the dealer locator to find your nearest dealer/distributor